Propellerhead Reason - 3.0 - Control Surface Details Guide de l'utilisateur télécharger pdf (Page 10)

Evolution

MK-249C

Requirements/Setting up:

To be able to use the ten buttons on the MK-249C, you need to program them so that

they send out the following MIDI program change messages:

button 0 : MIDI program change # 00

button 1 : MIDI program change # 01

button 2 : MIDI program change # 02

button 3 : MIDI program change # 03

button 4 : MIDI program change # 04

button 5 : MIDI program change # 05

button 6 : MIDI program change # 06

button 7 : MIDI program change # 07

button 8 : MIDI program change # 08

button 9 : MIDI program change # 09

About the default mapping:

D Buttons 8 and 9 are used for Target Previous/Next Track (move the mas-

ter keyboard input up or down in the track list).

D For devices with patches, buttons 6 and 7 are used for Select Previous/

Next Patch.

D For effect devices, button 0 controls the Bypass/On/Off status.

D With most Reason devices, the Master Volume Fader (below the display)

is mapped to the Master Level.

D On the Redrum and Matrix, button 1 steps through pattern 1-8 in the se-

lected bank, while button 2 steps through bank A-D. Button 0 controls

the Pattern Enable switch:

D When controlling devices with many parameters, keyboard shortcut vari-

ations are used.

MK-425C

Requirements/Setting up:

• Reason will automatically find the MK-425C if you click the Auto-detect button on

the Control Surfaces and Keyboards page in the Preferences.

• To use MK-425C with Reason, you need to select preset 4 and make sure this

isn't changed from the factory settings.

• If you have connected the keyboard via USB, Reason will restore preset 4 to fac-

tory settings for you - however, note that you need to select preset 4 manually after

this is done.

• You can also restore your MK-425C manually by holding down the + and - buttons

when you turn the keyboard on - note that this restores all presets to factory set-

tings, deleting any changes you have made.

About the controls:

The keyboard and performance controls, the eight knobs and the ten keypad buttons

are available as control surface items in Reason.

About the default mapping:

D On the keypad, buttons 4 and 7 are used for Target Previous/Next Track.

D Buttons 6 and 9 are used for Select Previous/Next Patch, where applica-

ble.

D For effect devices, button 0 controls the Bypass/On/Off state.

D When controlling devices with many parameters, keyboard shortcut vari-

ations are used.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Commentaires sur ces manuels

Pas de commentaire

Propellerhead Reason - 3.0 - Control Surface Details Guide de l'utilisateur Page 10

Commentaires sur ces manuels