Propellerhead Reason Spécifications télécharger pdf (Page 238)

THE EFFECT DEVICES

236

With this algorithm, raising the Decay setting on the main panel will make the re-

verse reverb start earlier and build up under a longer time. Similarly, the HF

Damp parameter affects how fast the high frequencies are built up in the reverse

reverb. In the remote panel, the Reverse algorithm has the following parameters:

| Parameter | Description

Length This sets the time from when the source signal is fed into the

reverb until it is played back again. It is during this time you

will hear the reverse reverb, as shown in the display.

The time can be set in milliseconds or as note values, de-

pending on whether Tempo Sync is off or on.

Note: As stated above, the Decay setting determines the

length of the actual reverse reverb - in essence how soon it

starts after the source signal. But of course, the reverse re-

verb cannot start before the original source signal! If you set

Decay to a longer time than the Length setting, the reverse

reverb will start abruptly, immediately when the source signal

is fed into the reverb. If this sounds complicated, just take a

look at the RV7000 display and try the settings - you will

soon see how it works.

Note also that very high Length settings demand a lot of pro-

cessor power. This can be reduced by adjusting the Density

parameter, see below.

Density Density governs the “thickness” of the Reverse effect. If this

parameter is turned down to zero, the effect produces indi-

vidual delays rather than a dense “wash”, which can be used

as a special effect. Worth noting is that if Density is set to

around 50%, this can considerably reduce the CPU load

without altering the sound of the effect too much. Exactly

how much the Density parameter can be reduced without al-

tering the sound depends on the source material.

Rev Dry/Wet Sets the balance between the “moved” source signal (“dry”,

low values) and the reverse reverb (“wet”, high values).

Tempo Sync Determines whether the Length setting should be freely set

(“off”) or synchronized to Reason’s tempo (“on”).

1 2 ... 233 234 235 236 237 238 239 240 241 242 243 ... 297 298

Vikitvv 04 Jan 2024 | 13:04:50

urenrjrjkvnm

Evabhf 07 Jan 2024 | 16:01:45

Med

Viktoridbv 14 Jan 2024 | 00:33:23

Cinema

Propellerhead Reason Spécifications Page 238